Publicité
Les langues disponibles
Les langues disponibles
WIRING
Risk of electric shock . Electrical wiring must be
done by qualified personnel in accordance with all
applicable codes and standards . Before connecting
wires, switch power off at service panel and lock
service disconnecting means to prevent power from
being switched on accidentally .
NOTES: 1 . Use appropriate wire nuts (not included) for wire
2 . Refer to FIG . 31 for wire connections .
1 . Connect GREEN or bare wire from house power cable to
one of the unit GREEN ground screw (
2 . Connect house power cable to unit wiring: BLACK to
BLACK (
3 . Connect No . 2 14/2 cable to unit wiring: BLACK to
BROWN (
4 . Using a short ground wire (not provided), connect GREEN
or bare wires from no . 1 and no . 2 cables to the other unit
GREEN ground screw (
5 . Connect No . 1 14/3 cable to unit wiring: RED to RED (
BLACK to ORANGE (
6 . Reinstall the electrical cover in the unit; ensuring the bottom
tabs are inserted in their embossed location . Secure in
place using its retaining screw (FIG . 32) .
NOTE: Not all wires shown .
Take care not to pinch wires while reinstalling wiring
cover .
INSTALL THE FILTER
Ducted Installation
Reinstall the grease filter .
Non-Ducted Installation
Attach the non-ducted filter (included with the HARKPM21
non-duct kit) to the back of the grease filter using
clips (provided with non-ducted filter) . To order a new
non-ducted filter, use service part number S99010464 .
16
!
WARNING
connections .
) and WHITE to WHITE (
) and WHITE to BLUE (
) .
) and WHITE to PURPLE (
CAUTION
) .
) .
) .
),
) .
2
9
8
1
7
NO. 1
14/3 CABLE
HE0449A
TABS
HD1379
4
5
HOUSE
POWER
CABLE
6
NO. 2
14/2 CABLE
FIG. 31
FIG. 32
Publicité
