Publicité
Les langues disponibles
Les langues disponibles
INSTALL THE UNIT
1 . Run house power cable between service panel and unit
location . Stub out a 2-foot length of power cable inside
the cabinet . Insert the power cable in the unit through one
of the 7/8" diameter strain relief previously installed .
NOTE: Not necessary if the optional HCK44 cord
connection kit is used .
2 Stub out a 2-foot length of both 14/2 cable and 14/3 cable
coming from switches . Insert the 14/2 cable and the
14/3 cable in the unit through the other 7/8" diameter
strain relief previously installed .
3 . Insert the unit in the cabinet, until you feel a 'click' from
both sides of the unit, confirming that the Ease of Install
Hooks rest on the top of the cabinet bottom sides , or
cabinet brackets or (FIG . 24) . Move the unit from
left to right, from rear to front and up to ensure the Ease
of Install Hooks are retaining the unit inside the cabinet .
NOTE: The unit will be protruding below the cabinetry until
tightened .
NOTE: If, for any reason, the unit has to be removed from
the cabinet, it is possible to disengage the Ease of
Install Hooks . To do so, while holding and pushing on
one side of the unit, lift simultaneously Ease of Install
Hooks levers (1 and 2, grey parts in FIG . 25) in the
other side of the unit until the hooks are retracted .
HD1374
HD1375
FIG. 24
2
1
FIG. 25
13
Publicité
