Publicité
Starting the extractor:
Tap (push) the Selection area (6) to enable the hob
Extraction speed (power):
The hob features 8 suction power levels
Tap and swipe with your fingers onto the Selection zone (3):
to the right to increase the suction speed (power) (0-8);
to the left to decrease the suction speed (power) (8-0);
Extraction speed (power):
Touch and slide your fingers along the Selection bar (6):
to the right to increase extraction speed (power) (0-9);
to the left to decrease extraction speed (power) (9-0).
The product has an additional 1 timed extraction speeds
(power levels):
"
" for 5 minutes
after that the power returns to level 9.
Timer
Activation/Regulation of Timer function for the
extractor fan
• Select the extractor fan.
• Push
(8) to access the Timer function (at any
speed)
• Set the duration of the Timer:
press the selector
down time
push the selector
down time
display (15) will show the countdown,
Note: the symbol "
"(19) appears beside the display of the
extractor fan
When the timer has finished the count, it emits a beep (for 2
minutes; you can mute it by tapping
display (15) is flashing, showing the symbol " .
To switch-off the Timer:
• select the Selection zone (6)
• set the value of the timer to " " , via
Note: the function remains active if no other key is pressed
in the meantime.
, to increase the automatic shut-
, to decrease the automatic shut-
) , while the
".
Activation of filter saturation indicators
These indicators are normally deactivated
(for both the grease filter and the activated carbon filter)
To activate them, proceed as follows:
- switch on the extractor hob by means of
- with the suction motor and the cooking zones turned off,
push and hold down the Selection area (7):
the LED "
" (17) turns on at low brightness
the display (14) of the extractor fan shows the letter "G" – to
proceed with the activation of the grease filter saturation
indicator –
Note : push the Selection zone (7) again to display (14) the
letter "F" and proceed the odour carbon filter
Active
- push the Selection zone (6), the LED "
switches to high brigthness, then, after 10 seconds, it
turns off and indicates that the ACTIVATION was
completed.
Deactivation of filter saturation indicators
repeat the operation described above for activation;
- the LED "
after 10 seconds, it turns off to indicate that
DEACTIVATION was completed.
Filter saturation indicator
The hood indicates when it is necessary to perform
maintenance on the filters:
Grease filter
the LED "
"(17) turns on
the display (14) shows the symbol "G" (for 10 seconds from
switching on)
Activated carbon odour filter
the LED "
"(17) flashes;
the display (14) shows the symbol "F" (for 10 seconds from
switching on)
Reset filter saturation
After having serviced the filters (both the grease and/or the
odour activated carbon filters) press and hold the Selection
Area (7):
The LED "
" goes out and the indicator count is
restarted.
Note: Repeat the operation if both filters signals are displayed
simultaneously.
64
;
" (17) switches to low brightness, then,
" (17)
Publicité
