Publicité
When the timer has finished the count, it emits a beep (for 2
minutes; you can mute it by tapping
display (15) is flashing, showing the symbol " .
Note: with the Egg Timer active, appears the symbol "
(20)
Pause
The Pause function allows to suspend any function active on
the hob, bringing the cooking power to zero.
Activation:
• push
(10)
• on display will appear a " " (13).
To deactivate the function:
Note : this operation restores the hob conditions prior to the
pause.
• push
(10)
• within 10 seconds slide your fingers to the right along
theSelection zone (3), corresponding to the desired
cooking zone.
(FIG.19);
Note : if the operation is not performed during this time
the pause function will remain active.
Note: if after 10 minutes, the Pause Function is not
deactivated, the hob switches off automatically.
Recall
The Recall function allows to recover all the hob settings, in
case of accidental shut-down.
Activation:
• switch the cooktop on again
within 6 seconds after shut-down
• push "
"
within the next 6 seconds
Automatic Heat UP
The Automatic Heat UP function allows you to bring the set
power up to speed; with this function, we have the advantage
of having a faster cooking, but without the risk of burning the
food, because the temperature does not exceed that of the set
level.
This function is available for power levels 1-8 .
Activation:
• push and hold the Selection zone (3), the desired power
) , while the
".
• on display appears a " "
"
Power Limitation
The Power Limitation function allows the product to be used
while limiting its maximum consumption.
Note : the limit must be set when the hob is off, without
pressing the key
the electrical network, or when the electrical network itself is
reconnected, within the following 2 minutes.
To set the Power Limitation:
- push and hold the keys
beep
- simultaneously swipe onto the selection zones FL and RL
then push and hold down the area corresponding to the last
power level
to indicate that it is possible to run the setup
-- then press key
PHA (Phase power limit):
- the FL zone display shows the current setting**
0 = 7.4 KW
1 = 4.5 KW
2 = 3.1 KW
** by default, the limit is set to 7.4 KW
- to change the Power Limitation setting scroll on the FL
selection areas
- to save the selection press the keys
second;
a beep will be emitted to confirm the setting; the function will
close.
USING THE EXTRACTOR FAN
Switch-on
Push (tap)
The indicator light will turn on to indicate that the hob/extractor
is ready for use
Press again to turn off
Note: This function has priority over the others.
63
(13).
, at the time of the hob's connection to
, until you hear a short
, from left to right,
, until you hear a short beep
- the Timer (15) display shows the symbols "CF6",
and the timer display (15) will show
,
ON/OFF button of hob/extractor fan
, for 1
Publicité
