Russell Hobbs RHI802 Manuel D'instructions page 6

SPRAYING

Press the spray button to spray water on clothes, as often as required.
Please Note: When using the water spray function, ensure that there is enough water in
the water tank, and you may have to pump the spray button several times at first in order
to start the spraying function.
BURST OR VERTICAL STEAM IRONING

Press the burst of Steam button to generate a powerful burst of steam that can
penetrate the fabrics and smooth the most difficult and tough creases. Wait for a
few seconds before pressing again.

By pressing the Burst of Steam Button you can also iron vertically (e.g. curtains)
Please Note: The burst steam function can only be used at high temperature. Stop the
emission when the pilot light turns on, and then start ironing again only after the pilot
light has turned off.
DRY IRONING
For ironing without steam, follow the instruction in section "steam ironing", however, the
steam control turning knob should remain in position "O" (no steam).
FABRIC & TEMPERATURE INDICATOR
Use the Electronic Temperature Control to select the desired fabric setting. The lights in
the water tank will light up, at the same time lights will start to flash; they will stop
flashing when the iron reaches the selected temperature.
CLEANING AND MAINTENANCE

This appliance is for household use only and is not user-serviceable.

Do not open or change any parts by yourself. Please refer to a qualified electrical
service department or return to the supplier if servicing is necessary.

Always remember to unplug the unit from the electrical outlet when not in use
and before cleaning. Ensure that the speed control is set to "0".

It is much easier to clean the accessories directly after they have been used.
Wash them in warm, soapy water, rinse and dry well.
All manuals and user guides at all-guides.com
6