Russell Hobbs RHI802 Manuel D'instructions page 5

FILLING WITH WATER

We recommend the use of distilled or kettle water.

Make sure that both the Steam Control turning Knob and Temperature Control
Dial are in the "OFF" position.

Hold the iron upright so that the water-filling inlet is in a horizontal position.

Fill with water through Water Filling Inlet until the water reaches the "MAX" mark
indicated on the side of the iron, and never fill above this mark.
SETTING TEMPERATURE
Follow the ironing instructions on the garment label. If there is no instruction but you do
know the kind of fabric, please consult the following table.
Note: If the fabric consists of various kinds of fabrics, always select the temperature
required by the most delicate fabrics.
Fabric
Synthetic
Silk, wool
Cotton, linen
STEAM IRONING

Place the iron in a vertical position and set the temperature control dial to the
minimum/lowest heat setting.

Insert the plug into the socket, and then turn the temperature control dial to the
"high heat" marking. The pilot light will come on, indicating that the iron is heating
up.

When the pilot light turns off, the set temperature has been reached and the iron
is ready to use.

During ironing, the pilot light on the iron automatically switches on/off as the
thermostat maintains the set temperature (you may continue ironing during this
process).

Turn the steam control turning knob to the required position.

Steam is produced as soon as the iron is held horizontally.
All manuals and user guides at all-guides.com
Temperature control
●
●●
●●●
5
Temperature requirement
Low temperature
Medium temperature
High temperature