Publicité
Les langues disponibles
Les langues disponibles
REGULAR CLEANING
wWARNING:
• Unplug the washer before cleaning to avoid the risk of electric shock. Failure to follow this warning
can cause serious injury, fire, electrical shock, or death.
• Never use harsh chemicals, abrasive cleaners, or solvents to clean the washer.
They will damage the finish.
Cleaning the Exterior
Proper care of your washer can extend its life. The outside
of the machine can be cleaned with warm water and a mild,
nonabrasive household detergent.
Immediately wipe off any spills with a soft, damp cloth.
IMPORTANT: Do not use methylated spirits, solvents, or
similar products.
Never use steel wool or abrasive cleansers; they can damage
the surface.
Care and Cleaning of the Interior
Use a towel or soft cloth to wipe around the washer door
opening, door seal, and door glass. These areas should be
kept clean to ensure a watertight seal. Be sure to wipe under
the inside rubber seal to remove any moisture or soil.
Always remove items from the washer as soon
as the cycle is completed. Leaving damp items in the washer
can cause wrinkling, color transfer, and odor.
Run the TUB CLEAN cycle regularly to remove detergent
buildup and other residue.
NOTE: NOTE: If you use the TUB CLEAN cycle on a
monthly basis, the wash drum will be kept clean.
Cleaning the Steam and Water
Circulation Nozzles
Use a cotton swab to remove lime or detergent buildup from
the inside of the steam and water circulation nozzles. NEVER
use a sharp or pointed object; you could damage the nozzles.
Removing the Stain in Door Seal
NOTE: Wear rubber gloves and eye protection while
performing the following procedure:
1
Dilute 3/4 cup (177 ml) liquid chlorine bleach with
1 gallon (3.8 L) of warm/hot water.
Use this solution to wipe down all surfaces of
2
the gasket to remove the deposits that are causing
any odor. (Be sure to fold back the lip of the gasket
to get under the edge where residue can build up.)
3
Wipe the gasket with a dry cloth.
Leave the door open to allow the gasket to dry
4
completely.
Do not use undiluted bleach as this will damage the gasket.Follow
the manufacturer's instructions for proper use of bleach.
If the gasket cannot be cleaned properly, it should be replaced.
C A R E A N D C L E A N I N G
C A R E A N D C L E A N I N G
Read these instructions carefully before
beginning the TUB CLEAN cycle.
1
Open the door and remove any clothing in
the wash drum.
2
Open the dispenser drawer.
3
Add liquid chlorine bleach or tub cleaner.
Some powder or tablet tub cleaners which
are manufactured for this purpose can be
used.
(NOTE : Do not add any laundry detergent
or fabric softener to the drawer when using
TUB CLEAN.)
- If using liquid chlorine bleach
Add liquid chlorine bleach to the bleach
compartment of the drawer.
(NOTE : Do not exceed the maximum
fill line and do not pour undiluted liquid
bleach directly into the wash drum.)
- If using powder cleaner
Remove the liquid detergent cup and
add powder cleaner to the main wash
compartment of the drawer.
- If using tablet cleaner
Add tablet cleaner to the wash drum
directly.
(NOTE : Do not add tablet cleaner to the
drawer.)
4
Close the drawer and washer door.
5
Select TUB CLEAN and press START.
NOTE : It is recommended that TUB CLEAN
should be repeated monthly.
If mildew or musty smell already exists, run TUB
CLEAN for 3 consecutive weeks.
After TUB CLEAN is complete or when the washer
is not used, leave the washer door open for better
ventilation and drying inside of the washer.
27
Publicité
