Publicité
Les langues disponibles
Les langues disponibles
I N S TA L L AT I O N I N S T R U C T I O N S
LEVELING THE WASHER
The drum of your new washer spins at very high
speeds, up to 1,300 RPM. To minimize vibration,
noise, and unwanted movement, the floor must
be a perfectly level, solid surface.
NOTE: Adjust the leveling feet only as far as
necessary to level the washer. Extending the
leveling feet more than necessary can cause
the washer to vibrate.
Leveling Feet
Position the washer in the final location,
1
taking special care to not pinch, strain, or
crush the water and drain lines. Place a level
across the top of the washer.
Raise
Loosen the locknuts on all 4 leveling feet
2
until you can turn the feet with the included
wrench. Turn clockwise to raise the washer or
counterclockwise to lower it.
INSTALLATION OF NON-SKID PADS (OPTIONAL)
Some floor surfaces are too slippery to prevent
the washer from moving on the floor during
heavily unbalanced loads. While it is normal for
an occasional load to be out of balance, excess
noise and vibration can result from the washer
moving out of position. If these conditions are
encountered, follow the instructions below for
installation of the non-skid pads. These pads
will help prevent the washer from moving during
heavy out of balance conditions thereby reducing
noise and vibration.
14
• All four leveling feet must rest solidly on the fl oor.
If you are installing the washer on the optional
pedestal, you must use the leveling feet on the
pedestal to level the washer. The washer's leveling
feet should be fully retracted and locked into
position with the locknuts.
Level
Leveling Feet
Lower
•Non-skidpads
✻ Placethepadsunderbothfrontfeet.
Rock the washer gently from corner to corner to
make sure that the washer does not rock.
Once the washer is level from side to side and
3
front to back, tighten all locknuts securely.
Make sure that all 4 leveling feet are in firm
contact with the floor.
NOTE: To make sure that the washer is
properly level, run the washer with a test load:
place approximately 6 pounds of laundry
in the machine. Then press POWER, press
RINSE+SPIN, and then press the START/
PAUSE button. See the following sections for
additional information on cycle selection and
operation.
Verify that the washer does not rock or vibrate
excessively during the spin cycle. If the
washer vibrates or shakes, adjust the leveling
feet until the washer is stable and retest.
This side up
Stick adhesive side to floor
Remove backing
Tighten all 4
locknuts securely
Publicité
