Victron energy Skylla-i 24/80 1+1 Skylla-i 24/80 3 Skylla-i 24/100 1+1 Skylla-i 24/100 3 Manuel page 3

1. SAFETY INSTRUCTIONS
1.1. General
● Please read the documentation supplied with this product first, so that you are familiar with the safety signs and directions before
using the product.
● This product is designed and tested in accordance with international standards. The equipment should be used for the
designated application only.
● WARNING: danger of electric shock
The product is used in combination with a permanent energy source (battery). Even if the equipment is switched off, a dangerous
electrical voltage may still be present at the input and/or output terminals. Always disconnect the AC power and the battery before
performing maintenance.
● The product contains no internal user-serviceable parts. Do not remove the front panel unless the mains and the battery are
disconnected. Do not put the product into operation unless all panels are fitted. All maintenance should be performed by qualified
personnel.
● Never use the product at sites where gas or dust explosions could occur. Refer to the specifications provided by the manufacturer
of the battery to ensure that the battery is suitable for use with this product. The battery manufacturer's safety instructions should
always be observed.
● WARNING: do not lift heavy objects unassisted.
1.2. Installation
● Read the installation instructions before commencing installation activities.
● This product is a safety class I device (supplied with a ground terminal for safety purposes). It's AC input and/or output
terminals must be provided with uninterruptible grounding for safety purposes. An additional grounding point is located
on the outside of the product. If it can be assumed that the grounding protection is damaged, the product should be taken out
of operation and prevented from accidentally being put into operation again; contact qualified maintenance personnel.
● Ensure that the connection cables are provided with fuses and circuit breakers. Never replace a protective device by a
component of a different type. Refer to the manual for the correct part.
● Check before switching the device on whether the available voltage source conforms to the configuration settings of the product
as described in the manual.
● Ensure that the equipment is used under the correct operating conditions. Never operate it in a wet or dusty environment.
● Ensure that there is always sufficient free space around the product for ventilation, and that ventilation openings are not blocked.
● Install the product in a heatproof environment. Ensure therefore that there are no chemicals, plastic parts, curtains or other
textiles, etc. in the immediate vicinity of the equipment.
1.3. Transport and storage
● During storage or transport of the product, ensure that the mains supply and battery cables are disconnected.
● No liability can be accepted for damage in transit if the equipment is not transported in its original packaging.
● Store the product in a dry environment; the storage temperature should range from –20 °C to 60 °C.
● Refer to the battery manufacturer's manual for information on transport, storage, charging, recharging and disposal of the
battery.
3