Publicité
Les langues disponibles
Les langues disponibles
5. After the washer is level, and all four feet are in firm contact with the floor, use a
9
/
" (14 mm) open-end wrench to turn the locknuts on the feet, tightly against the
16
washer cabinet.
IMPORTANT: All four feet must be tightened. If the locknuts are not tight against the
washer cabinet, the washer may vibrate.
6. The washer should not move front to back, side to side, or diagonally when pushed on its
top edges.
7. Confirm the levelness of the washer.
Complete Installation
1. Check the electrical requirements. Be sure that you have the correct electrical supply and
the recommended grounding method. See "Electrical Requirements."
2. Check that all parts are now installed. If there is an extra part, go back through the steps to
see which step was skipped.
3. Check that you have all of your tools.
4. Dispose of/recycle all packaging materials.
5. Check that the water faucets are on.
All manuals and user guides at all-guides.com
6. Check for leaks around faucets and inlet hoses.
7. Plug into a grounded 3 prong outlet.
8. Read "Washer Use."
9. To test and to clean your washer, measure ½ the detergent manufacturer's recommended
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
amount of HE High Efficiency detergent for a medium-size load. Pour the detergent into
the detergent dispenser. Select NORMAL, and then select START. Allow the washer to
complete one whole cycle.
Use only HE High Efficiency detergent.
13
Publicité
