DYNAMIC BLADE BALANCING KIT
INSTRUCTIONS
Preface
•
Your ceiling fan may sometimes have wobbling problems when
operating due to irregularity in the blades or the blade holders.
Improper assembly in the mounting system may cause some
additional problems. This balancing kit can be used to fix wobbling
problem.
Dynamic Blade Balancing Kit
Warning: If any of the blades are bent or damaged, do not
•
use the unit any further.
01.
Make sure that all blades are firmly screwed into the blade holder.
02.
Make sure that all blade holders are firmly secured to the motor
housing and check that the pitch of blade holders is the same for all.
03.
By looking up at the fan from below, check and be certain that none
of the blade holders are bent and that none of the blades are out of
position.
04.
Use a ruler to check the blade tracking. Put the ruler up against the
ceiling vertically and against the outside leading edge of a blade.
Note the distance of the edge of blade to the ceiling. Carefully turn
the blades slowly by hand to check the remaining blades. If the
blade is not in alignment, the blade holder may be gently bent up or
down to be in line with the other blades.
After following all the steps if the wobbling problem is not solved, a
•
dynamic balancing needs to be done with balancing kit. Follow the
procedure listed:
Ruler
1
2
3
4
5
6
Measuring
7
Point
8
9
23
08
Balancing
Weight
Plastic Clip
Centre Line
Counter-
Clockwise