Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
10
Remove 1 of the 2 screws from the bottom of the hanger bracket and loosen the other one
half a turn from the screw head. Slide the canopy up towards the hanger bracket and place
the key hole on the canopy over the screw on the hanger bracket, then turn canopy until it
locks in place at the narrow section of the key holes. Align the circular hole on the canopy
with the remaining hole on the hanger bracket, secure with previously removed hanger
bracket screw, and tighten both hanger bracket screws securely (Fig. 10).
Push up the canopy cover until the screw heads engage to the slots on the canopy cover
and rotate the canopy cover until it is attached to the bottom of the canopy securely (Fig. 10).
NOTE: Adjust the canopy screws as necessary until the canopy and canopy cover are snug .
11
Attach a blade to the fan motor assembly by inserting the blade into the slot in the side of the
fan motor assembly. Align the blade screw holes with the screw holes in the motor assembly.
Using three blade screws and fibre washers attach the fan blade. Tighten screws securely
(Fig. 11). Repeat for all remaining blades.
Canopy
Screw
Blade Screw Holes
Fiber Washer
Fig. 11
Hanger
Bracket
Hanger
Bracket Screw
Canopy
Key
Hole Slot
Canopy
Cover
Fig. 10
Blade Screw
17
05
Blade
Publicité
