NOMA MARSHALL 52 Manuel D'utilisation page 14

Collar Screws
Hanger
Pin
05
Insert and tighten the two collar screws.
Slide lock pin into hanger pin until it is
locked into position (Fig. 5).
Cross Pin
Hanger Ball
07
Carefully reinstall the hanger ball onto rod,
being sure that cross pin is in correct position,
set screws are tightened and wires are not
twisted (Fig. 7).
Lock Pin
Fig. 5
Set Screw
Fig. 7
Hanger Ball
Motor Wires
Hanger
Pin
06
Slide downrod cover, canopy cover and
canopy over the downrod as shown (Fig. 6).
Slot
08
Hang the fan onto the hanger bracket,
and make sure the slot of the hanger ball
is aligned with the clip of the hanger
bracket (Fig. 8).
14
Safety Cable
Downrod
Canopy
Canopy Cover
Downrod Cover
Lock Pin
Collar
Fig. 6
Hanger
Bracket
Clip
Fig. 8