Dometic GROUP Waeco CoolAir SP950 Notice De Montage page 46

Installation
6.3.4 Menu level 3: Operating mode
The unit always starts with a defined operating mode for room tempera-
ture. This parameter can be configured:
➤ Start configuration mode (chapter "Starting and ending configuration
mode" on page 44).
✓ The first digit of the display (fig. 0 5,page 9) shows the menu level
and the second and third show the parameter which can be set.
➤ Press the + button (fig. 0 6,page 9) twice to switch to menu level 3.
➤ Press the Operating Mode button (fig. 0 4,page 9) to change the
parameters.
✓ The digits in the display flash until the parameter you entered is
confirmed.
➤ Use the + and – buttons (fig. 0 6 and 7, page 9) to set the mode with
which the unit starts up:
Characteristic fig-
ure
0
1
2
3
➤ Press the Operating Mode button (fig. 0 4,page 9) to confirm your
entry.
✓ The set value is saved and is then used when the unit is restarted.
✓ You are now in menu level 3 again and can use the + and – buttons to
switch between menu levels.
6.3.5 Menu level 4: Default setting
You can reset the parameters you set in configuration mode on menu
levels 1 to 3 to the default settings:
➤ Start configuration mode (chapter "Starting and ending configuration
mode" on page 44).
✓ The first digit of the display (fig. 0 5,page 9) shows the menu level
and the second and third show the parameter which can be set.
➤ Press the + button (fig. 0 6,page 9) three times to switch to menu
level 4.
✓ The digital display shows
46
Operating mode
Automatic mode
Operating mode 1
Operating mode 2
Operating mode 3
.
--
CoolAir RT880, SP950
EN