Dometic GROUP Waeco CoolAir SP950 Notice De Montage page 40

Installation
6.2.2 Preparing the unit (RT880 only)
NOTICE!
A
During preparatory work on the surfaces, secure the unit from falling
down.
Make sure that the work surface is clean and level to ensure that the unit
is not damaged.
➤ Place the air conditioning roof unit on a work surface with the housing
facing down.
NOTICE!
A
Screw in the thread insert vertically.
Do not exceed the screw torque of 10 Nm.
➤ Screw in the 6 self-threading M8 thread inserts in the blind holes
marked with "2" (fig. 3 1, page 4).
Use the supplied 1/4" bit for this.
6.2.3 Attaching the seal for the cab roof
A NOTICE!
Ensure that the adhesive surface for the seal between the unit and the
cab roof is clean (free of dust, oil, etc.).
➤ Stick the 2.5 m insulating tape (10 x 20 mm) to the cab roof, following
the outline of the sunroof opening (fig. 4, page 4).
➤ Provide the abutting edge and the top edge of the insulating tape with
an unhardened plastic butyl sealing compound (e.g.
SikaLastomer-710).
40
CoolAir RT880, SP950
EN