Publicité
Les langues disponibles
Les langues disponibles
INSTRUCTION MANUAL · AIR CONDITION
TIMER SETTING (1HOUR-24HOURS)
EN
The timer has two ways of operation:
To turn off
Press the Timer key
è
(When power
to turn on the timer
on)
function.
To turn on
Press the Timer key
(When power
è
to turn on the timer
off)
function.
Cancel timer
Press Up /Down repeatedly until the LED shows '00'.
Note: by pressing POWER you will also cancel the
è
timer
OVERLOAD PROTECTION
In the event of a power loss, to protect the compressor there is a 3-minute delay
until the compressor restarting.
DRAINAGE
SELF- EVAPORATING SYSTEM
The self-evaporating system uses the collected water to cool the condenser coils
for better, more efficient performance. There is no need to empty the drainage
tank in cooling mode, except in high humidity conditions. In drying mode, the
drainage tank needs to be emptied. The condensed water evaporates at the
condenser and disappears through the exhaust hose.
For continuous operation or unattended operating in drying mode, please
connect the attached drain hose to the unit. Condensed water can automatically
run into a bucket or drain.
• Switch off the unit before operating.
• Remove the plug of the water outlet opening and
keep it in safe area.
• Securely and properly connect the drain hose. Make
sure it is not kinked and clear of obstruction.
• Place the outlet of hose over a drain or bucket and
ensure that water can freely flow out of the unit.
• Do not submerge the end of hose into water; other-
wise it can cause "Air Lock" in the hose.
Press Up /Down
è
repeatedly to set the
delay OFF time.
Press Up /Down
è
repeatedly to set the
delay ON time.
Remove the
rubber sealing plug
Continuous drain hose
16
CHILL CONNECTED · AC1W-7000/ AC1B-7000C/ AC1B-9000C
TO AVOID WATER SPILLAGE
• As the negative pressure of condensate drain pan is large, tilt the drain hose
downward toward the floor. It is appropriate that the degree of inclination
should exceed 20 degrees.
• Straighten the hose to avoid a trapping water in the hose.
DISASSEMBLY AND CLEANING
CLEANING THE AIR FILTER (EVERY TWO WEEKS)
Dust collects on the filter and restricts the airflow. The restricted airflow reduces
the efficiency of the system and if it becomes blocked it can cause damage to
the unit.
The air filter requires regular cleaning. The air filter is removable for easy
cleaning. Do not operate the unit without an air filter, or the evaporator may be
contaminated.
1. Press POWER button to switch off the unit and unplug the power cord.
2. Remove the filter mesh from the unit.
3. Use a vacuum cleaner to vacuum dust from the filter.
4. Turn the filter over and rinse the air filter under running water. Let the water
run through the filter in the opposite direction of air flow. Set aside and allow
the filter to air dry completely before reinstalling.
Switch off the unit and
remove the two air filters.
Rinse the air filter under
running water.
17
EN
Publicité
