Berger Titanium Mode D'emploi page 42

GB
OPERATION - MANOEUVRING
Attention! Please read the safety instructions for operation carefully BEFORE you start using
your Berger Ragierhilfe Titanium�
Familiarise yourself with the arrangement of the remote control buttons by referring to Fig� 1
and the section „Operation - Functions of the remote control" in this manual�
Switch on the battery isolator switch� Activate the remote control by double-clicking the power
button (Fig�1�A)� The indicator LED (Fig�1�B) of the remote control lights up� Switch on both
drive units as described in the section „Operation - Switching on/off" in this manual� Before
operating the manoeuvring aid, release the handbrake�
Move the vehicle using the various buttons, always paying attention to your surroundings and
the terrain� In single-axle mode, the [FR] (Fig�1�D) and [RL] (Fig�1�G) or [FL] (Fig�1�E) and [RR]
(Fig�1�F) buttons must be pressed together to use the „turn on the spot" function� This function
is disabled in two-axle and AWD mode�
Turn on the spot options:
The soft start function of the motors means that the manoeuvring aid operates at a lower
speed for the fi rst 2�5 seconds� Note that the general speed may increase slightly when driving
downhill and decrease slightly when driving uphill� The manoeuvring aid is more effi cient when
the caravan is reversing up a slope�
After manoeuvring, apply the handbrake before disconnecting the drive rollers from the tyres�
Switch off the system by double-clicking the power button (Fig� 1�A) on the remote control� The
indicator LED (Fig�1�B) on the remote control goes out� Turn off the battery disconnect switch to
cut off the power supply to the electronic control unit(s)�
Keep the remote control and the battery disconnect switch in a safe place (out of reach of child-
ren or other unauthorised persons)�
After manoeuvring, be sure to apply the vehicle's handbrake before disengaging the manoeuv-
ring aid or switching off the electronic unit or handset� Never rely on the manoeuvring aid to
act as a brake�
Coupling and uncoupling
It is possible to position the caravan's trailer coupling exactly over the trailer coupling of a stati-
onary vehicle using the manoeuvring aid, but this should be done with care�
Use the movement buttons on the remote control to move the caravan up to the car� It is better
to reach the trailer hitch with several short „trips" than to try to do it with one „trip"� When
the trailer hitch is just above the ball head of the car, lower the trailer hitch onto the ball head
42