Berger Titanium Mode D'emploi page 37

GB
load capacity (SWL)� DO NOT attempt to move or tow your vehicle with the drive rollers at-
tached to the wheels� DO NOT make any modifications to the manoeuvring aid (mechanical or
electronic)� This can be very dangerous! There is no warranty claim and we cannot guarantee
the function of the manoeuvring aid if modifications have been made� Fritz Berger GmbH is not
liable for damage caused by improper installation, operation or modification�
OPERATION - FUNCTIONS OF THE REMOTE CONTROL
Use Fig�1 to familiarise yourself with the structure of the remote control (1)�
Switching on:
Fig�1�A = Power button (press twice) Fig�1�B = LED display�
Movement controls:
Fig�1�C = Forward [F] Fig�1�D = Forward right [FR]�
Fig�1�E = Forward Left [FL] Fig�1�F = Reverse Right [RR]
Fig�1�G = Reverse Left [RL] Fig�1�H = Reverse [R]
Controls for engaging and disengaging the clutch:
Fig�1�I = Engage button [ENG] Fig�1�J = Disengage button [DENG]�
Fig�1�K = Automatic switch-on button [FN]�
The remote control (1) is powered by two 1�5 V „AAA" batteries� To insert the batteries, you
must remove the rear casing of the remote control as shown in Fig� 2� Make sure that only
leak-proof batteries are used� Check with your local authorities for the correct disposal of used
batteries� Remove the batteries from the remote control if it will not be used for a long time�
Press the power button twice (Fig�1�A) to switch on the remote control� As soon as it is swit-
ched on, the LED (fig�1�B) lights up� If the remote control has not been used for 60 seconds, it
switches off�
37