Berger Titanium Mode D'emploi page 38

GB
OPERATION - PAIRING THE REMOTE CONTROL / MODE SELECTION
The procedure for pairing the remote control depends on the confi guration of the manoeuvring
aid you have installed in your caravan� It is extremely important that the remote control is set
in the correct mode to ensure that the manoeuvring aid functions as intended� With two-axle
vehicles, for example, the turning possibilities are quite different from those of a single-axle ca-
ravan� Only if you set the manoeuvring aid correctly can you get the best possible performance
out of it�
Familiarise yourself with the functions of the remote control (see ‚Operation - Remote con-
trol functions') and the structure of the electronic control unit� These must be set to both the
correct model and mode for your axle confi guration� To set the correct model, follow the table
below:
Model
Manoeuvring aid
titanium
To set the correct mode, see the following sections:
Single-axis mode
Make sure the batteries are inserted in the remote control as described in the previous section
(Operation - Remote Control Functions)� Turn on the battery disconnect switch to supply power
to the electronic control unit (2); a red LED lights up� Press the power button twice (Fig�1�A) to
switch on the remote control�
On the remote control (1), press and hold the [ENG] (fi g�1�I) and [DENG] (fi g�1�J) buttons for one
second to enter pairing mode� The indicator LED (Fig�1�B) on your remote control should fl ash
green continuously� Press the small sync button (fi g�3) on your electronic control unit (2)� The
LED on this box should fl ash red rapidly before making a small clicking sound� The indicator LED
(Fig�1�B) on your remote control should be solid green and the LED on the electronic control
unit (2) should fl ash red slowly to indicate that the two are paired�
If you do not change this, the remote control will be in single axis mode by default� If the re-
mote control is not in default mode, press and hold the [FL] (fi g� 1�E) and [FN] (fi g� 1�K) buttons
for 5 seconds to select single axis mode� The remote beeps once to indicate that the mode has
been set to Single Axis� Once set, the remote control and control unit remember their assign-
ment and are fully functional after switching on�
38
Selection Description
Press and hold [FN] (Fig�1�K) and [F]
(Fig�1�C) for 5 seconds�
Buttons
5 sec 5 sec