Berger Titanium Mode D'emploi page 39

Two-axle mode:
Two-axis mode (only one driven axis)
Make sure that the batteries are inserted in the remote control as described in the previous
section (Operation - Remote Control Functions)� Turn on the battery disconnect switch to supply
power to the electronic control unit (2); a red LED lights up� Press the power button twice
(Fig�1�A) to switch on the remote control�
On your remote control (1), press and hold the [ENG] (fi g�1�I) and [DENG] (fi g�1�J) buttons for
one second to enter pairing mode� The indicator LED (Fig�1�B) on your remote control should
fl ash green continuously� Press the small sync button (fi g�3) on your electronic control unit (2)�
The LED on this box should fl ash red rapidly before making a small clicking sound� The indica-
tor LED (Fig�1�B) on your remote control should be solid green and the LED on the electronic
control unit (2) should fl ash red slowly to indicate that the two are paired�
The remote control is in single-axis mode by default� To select dual-axis mode, press and hold
[RL] (Fig�1�G) and [FN] (Fig�1�K) for 5 seconds� The remote beeps once to indicate that the mode
has been set to dual axis� Once set, the remote control and the control unit remember the
assignment and are fully functional after switching on�
Two-axle mode:
AWD mode (dual axle, both driven)
To confi gure your system for AWD mode, the remote control (1) only needs to be paired with
the electronic control unit of the front axle (2)� To do this, fi rst make sure that the data cable (4)
is correctly connected to both control units as described in the section „Installation - Electrical/
Electronic Components (AWD Confi guration)"� Make sure that the batteries are also inserted in
the remote control as described in the previous section (Operation - Pairing the remote control /
Mode selection)�
Turn on the battery disconnect switch to power both control units; a red LED lights up on each
box� Press the power button twice (Fig�1�A) to switch on the remote control�
On your remote control (1), press and hold the [ENG] (Fig�1�I) and [DENG] (Fig�1�J) buttons for
one second to enter pairing mode� The indicator LED (Fig�1�B) on your remote control should
fl ash green continuously� Press the small sync button (fi g�3) on the electronic control unit of
the front axle (2)� The LED on this box should fl ash red rapidly before a small clicking sound is
heard� The indicator LED (fi g�1�B) on your remote control should be solid green and the LED on
the electronic control unit (2) should fl ash red slowly to indicate that it is paired�
The remote control is in single-axle mode by default� To select AWD mode, press and hold the
[RL] (Fig�1�G) and [FN] (Fig�1�K) buttons for 5 seconds to fi rst select dual-axle mode� The remote
beeps once to indicate that the mode has been set to dual axis� Press and hold the [RL] (fi g�1�G)
and [FN] (fi g�1�K) buttons again for 5 seconds to select AWD mode� The remote control beeps
Single-axle mode:
Single-axle mode:
GB
39