Monthly Checks - grandimpianti WR 8 Instructions Pour L'installation Et Mode D'emploi

www.groupdynamics-laundry.com
sales@groupdynamics.lv
8.3 PERIODIC MAINTENANCE (to be
carried out by the technical personnel)
All maintenance operations must be carried
out by the authorised after-sales service or
by qualified personnel.
BEFORE ANY MAINTENANCE OR
CLEANING OPERATION, CHECK
THAT WALL CUT-OFF SWITCH IS
OFF AND THE HOT WATER, COLD
WATER AND STEAM TAPS ARE
CLOSED (STEAM TAP ONLY ON
STEAM HEATED MACHINES). THE
DRUM MUST BE STILL AND
DRAINED AND THE TEMPERATURE
INSIDE IT MUST NOT EXCEED 40°C.
Be very careful during maintenance. NEVER
exclude or ignore safety devices. Use only
original spare parts. If doubts should arise,
contact your sales person immediately,
explaining what the fault is and indicating
some information on the machine: model
and serial number (data reported on the
rating plate appearing at the rear of the
machine).

MONTHLY CHECKS

Clean the strains located on the outer part of
the electrically driven valves.
Make certain that the steam valve strain is
clean (only on steam heated machines).
Clean the soap dispenser from any powder
remains.
Clean the door gasket and the tub inlet with
a cloth.
YEARLY CHECKS
Make certain that the support fastening nuts
are securely closed.
Check the wear on the belts and replace them
if necessary. If more than one of them is
worn out, replace the whole set of belts.
Make sure that the safety devices are working
properly (e.g. the door microswitch)
Check that the floor fastening screws are
tight.
Make certain that the power connecting
screws are tight on the contactors and in the
terminal board.
Disassemble the drain valve and clean it
inside from lint.
Check that heaters are in perfect condition
and clean them from scale.
BEFORE TURNING THE MACHINE
ON BY THE CUTOFF SWITCH ON
THE WALL, PUT ALL THE PANELS
YOU HAVE REMOVED BACK TO
THEIR PLACE.
8.4 IDENTIFYING AND ORDERING
SPARE PARTS
To identify the codes of spare parts refer to
the exploded drawings and relative list. Once
you have identified your codes, send a
standard written order to the manufacturer,
mentioning clearly the model, serial number,
feed voltage and frequency of your appliance
and, of course, including the code and
description of the spare part you need.
9 SUGGESTIONS FOR PUTTING THE
DISPLAY CASE OUT OF SERVICE,
DISMANTLING AND DISPOSING OF IT
If the washing machine is no longer to be
used, it is advisable to put it out of service
and suitably dispose of the resulting
materials, considering the indications
provided in chapter 3. For the sake of the
environment, please sort the materials in
accordance with the waste disposal
provisions in force in your country, so that
they can be properly disposed of or recycled.
All of the parts composing the case can be
treated as solid urban waste, except for the
metal parts, which nevertheless are not
classed among special waste in most
European countries.
.
11