Hoover AXI HDPN 4S622PX Mode D'emploi page 107

"HALF LOAD" button
If you need to wash just a few dishes (e.g.
glasses, cups, plates), you can enabled the
"HALF LOAD" option.
In this way, you can save water, energy and
time. With the "Half Load" option, use less
detergent than for a full load.
"EXTRA DRY" button
This option allows you to achieve the
highest efficiency in drying, increasing the
wash water temperature during the last
phase of the wash cycle.
"SALT EMPTY" indicator light
When the indicator light comes on, fill
the salt container.
"RINSE AID EMPTY" indicator
light
When the indicator light comes on, the
rinse aid is running out and needs to be
topped up.
"START DELAY" button
Dishwasher start time can be set with this
button, delaying start from 1 to 23 hours.
Proceed as follows to set a delayed start:
l
Press the START DELAY button ("0:00"
will appear on the display).
l
Press the button again to increase the
delay in hours (each time the button is
pressed, the delay is increased by 1 hour
to a maximum of 23).
If you do not want a delayed start, press
the Start Delay button repeatedly until
0:00 appears on
appliance will start immediately).
l
To start the countdown, press the
"Start/Reset" button. The display will
show the time remaining to the end of the
programme. At the end of the countdown,
the programme will start automatically.
the display (the
107
(Only for free-standing models)
The length of the selected cycle will
be shown on the display. At the end of
the countdown, the programme will
automatically start and the length of
the selected cycle will be shown on
the display.
Proceed as follows to cancel a delayed
start:
l
Hold the "Start/Reset" button down for at
least 3 seconds. "00" will appear on the
display "RESET" and audible signals will
sound.
l
The delayed start and the selected
programme will
dashes will appear on the display.
l
At this point, to set off the dishwasher, a
new programme and any option buttons
must be selected, as indicated in the
"PROGRAMME SETTINGS" paragraph.
Muted END-OF-PROGRAMME signal
The product is set in the factory with the
audio signal enabled.
The audio signal may be muted as follows:
The dishwasher must ALWAYS be off
before you start this procedure.
1. Hold the "Progr." button down and, at
the same time,
dishwasher using the "ON/OFF" button.
2. "SETTING" appears on the display.
3. Press the Progr. button until "BUZZER"
appears on the display.
4. Then press either the button "HALF
LOAD" or "EXTRA DRY" to change
the value from Yes to No.
5. Switch off the dishwasher by pressing
the "ON/OFF" button to confirm the new
setting.
To turn the alarm on again, follow the same
procedure.
be cancelled. Two
switch on the