Hoover AXI HDPN 4S622PX Mode D'emploi page 105

When the door is shut, after an audible signal
has sounded, the programme will start
automatically. The display will show the time
remaining to the end of the wash cycle.
After switching on the dishwasher,
wait a few seconds for the programme
to start running.
"AUTOMATIC" programmes
(only on some models)
The dishwasher is equipped with a dirt sensor,
capable of analysing water murkiness during all
"AUTOMATIC" programme phases (see
programme legend). Thanks to this device,
the wash cycle parameters are automatically
adapted to the real quantity of dirt on dishes.
This is because water murkiness is linked to the
quantity of dirt on dishes. Thus, excellent
washing results are
optimising water and energy consumption.
"IMPULSE" programmes
The "IMPULSE"
impulse washing technology, which reduces
consumption and noise, and improves
performance.
The "intermittent" working of the
washing pump
considered a malfunction; it is a
characteristic of impulse washing,
and therefore should be considered a
normal feature of the programme.
ADDISH (possibility of adding dishes
after the programme has started)
When the programme starts, you should
only open the door and add more dishes
when the ADDISH
switched on. The appliance will stop
automatically and the time remaining to the
end of the cycle will flash on the display. Close
the door, without pressing any buttons.
guaranteed while
programmes use
is NOT to
indicator light is
The cycle will start from where it left off. When
the relating indicator light switches off, it is no
longer advisable to add further dishes.
Open the door slowly and carefully, to
avoid getting wet with splashes of
washing water.
Adding dishes
indicator light has switched off is
strongly discouraged as this could
affect the wash performance.
(Only for free-standing models)
The ADDISH feature can be used,
even without opening the door, by
pressing the Start/Reset button. In this
case, simply press the Start/Reset button
again to restart the cycle from where it
left off.
WARNING
If you open the door during the drying
cycle, an intermittent audio signal
advises you that the drying cycle has
an
not yet finished.
Power Wash
Proceed as follows to change or cancel a
be
running programme:
l
Hold the "RESET" button down for at least
3 seconds. "Start/Reset" will appear on the
display and audible signals will sound.
l
The running programme will be cancelled.
l
At this point a new programme can be set
using the "Progr." button.
WARNING
Before starting a new programme, you
should check that there is still detergent
in the dispenser. If necessary, top up the
detergent.
105
after the ADDISH