Publicité
Les langues disponibles
Les langues disponibles
Fan/Fan Mask
Dust or anything else may block the fan/fan mask and hinder the cooling efficiency of the
appliance. Vacuum the fan/fan mask if necessary.
16.3 Moving the appliance
Turn off the device first and then unplug the device from the wall outlet.
Remove all content. Shurely tape down all lose items inside your appliance.
Tape doors shut. Be sure the device stays in the upright position during transportation.
17 Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
17.1 Safety notices
► Only qualified electricians, who have been trained by the manufacturer, may carry out any
repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and damages
to the device.
17.2 Fault indications and rectification of faults
The following table assists in localizing and rectifying minor faults.
Fault
Device is not cold enough
The light does not work
Vibrations
The device seems to make too
much noise
Attention
Check the temperature control setting.
External environment may require a higher
setting.
The door is open too often.
The door is not closed completely.
The door seal does not seal properly.
The device does not have the correct clearance.
The fan cover is dirty. Please clean the fan cover.
Please call the warranty service number
Check to ensure that the device is level
The device is not level. Also,please check the fan.
Possible Cause
32
Publicité
