CASO DESIGN WineCase Red 12 Mode D'emploi page 30

14.1 Complete overview
(1) light (2) fan mask
(5) foot (6) bottom condensation water box
(9) lower cover and foot
(12) light switch
15 Operation and Handing
This chapter provides you with important notices with regard to operating the device.
15.1 Operating elements and displays
The device transmits the following signal sounds as an acoustic feedback signal:
► Use the buttons " " and " " to set the temperature in the range of 10-18°C.
steps from 10-18°C. You can tune the interior light on or off by pressing the "Light"
button. The temperature in the device depends on the room temperature, the quantity of
bottles and the chosen temperature. Please note that your device is only intended to cool
beverages. The maximum temperature that can be reached inside the device cannot be
significantly ABOVE the ambient temperature at the setup location.
(3) shelf (4) condensation water box
(10) door handle
Please note
(7) magnetic seal (8) door frame
(11) temperature control panel
You can set the temperature in C° and F°
as you desire by pressing the "C°/F°"
button.
With the buttons " " and " "on the panel
you can adjust the temperature in 1°C
30