Publicité
ERROR MESSAGES
If the start/stop switch or the reverse stitch switch is pushed,
when the sewing machine is not set up correctly, or if an incorrect
operation is made, the sewing machine will not operate, and a
buzzer will sound and an error message will be displayed.
When an error message is displayed, fix the problem following
the instructions in the message.
The error message will disappear once the problem has been
fixed.
EM-01 Check cable and power switch
Check that USB cable is connected and power switch is turned
on.
EM-02 Attach large hoop
Turn off power switch and attach large hoop.
EM-03 Bobbin winder in operation
Bobbin winder is in operation.
EM-04 Raise buttonhole lever
Buttonhole lever is lowered. Raise buttonhole lever.
EM-05 Lower presser foot
Lower presser foot by lowering presser foot lifter.
EM-06 Raise needle
Raise needle by rotating hand wheel toward you.
EM-07 Safety device activated
* This sewing machine is equipped with a safety device
which senses if the thread gets tangled up with the hook
during sewing, and automatically interrupts the flow of
current within 3 seconds to stop the motor from operating
when such a problem occurs.
* If this safety device has operated, turn off the power for the
sewing machine and eliminate the cause of the problem
that caused the sewing machine to stop.
* Then, turn the hand wheel toward you to check that the
sewing machine works normally again, and then re-start
the machine.
EM-08 Check bobbin winder
Check bobbin winder and move it to left.
EM-09 Thread breakage detected
Thread breakage is detected. Check threads.
90
EM-01
EM-02
EM-03
EM-04
EM-05
EM-06
EM-07
SAFTY DEVICE
ACTIVATED
EM-08
EM-09
Publicité
