Publicité
TURNING A SQUARE CORNER
1. To turn a square corner 5/8" (16 mm) from the fabric edge,
stop the machine and push the needle up/down switch to
move the needle to its lowest position when reaching the
cornering guide as shown. Raise the presser foot, turn fabric.
2. New stitching line will align with 5/8" (16 mm) seam guide on
side of needle plate. Lower the presser foot and begin stitching
in new direction.
REVERSE STITCH
It is a good idea to begin or end seams with 3 to 5 stitches in
reverse to reinforce the seams in order to prevent unraveling.
As long as you are pushing the reverse stitch switch, the machine
will continue to feed the fabric backwards.
TACKING (BASTING)
SETTINGS :Presser foot - Zigzag foot
:Feed dog control -
1. Push the needle up/down switch to move the needle to its
lowest position.
Push the switch again to raise the needle to its highest position.
2. Raise the presser foot lifter and move the material.
3. Lower the presser foot lifter and then push the needle up/
down switch two more times to sew another stitch.
RUNNING QUILT STITCH
This stitch is designed to look like hand sewing for topstitching
and quilting.
1. Thread bobbin with desired top stitching color.
2. Thread machine with invisible or same color thread which
matches fabric and will not show.
3. Increase thread tension a little.
4. Start to sew.
NOTE: When the upper thread is loosen, the machine may stop
in the beginning.
If the machine stops from the beginning, push the start
switch again.
40
02
Needle up/down switch
Positionnement haut/bas
de l'aiguille
Interruptor agja arriba/abajo
Reverse stitch switch
Interrupteur couture arrière
Interruptor de puntadas hacia atrás
Cornering guide
Guide d'angle
Guía de esquinas
Publicité
