Publicité
Les langues disponibles
Les langues disponibles
VACUUM SET UP AND OPERATION (CONT'D.)
4. Attach the desired cleaning accessory onto the accessory end of the hose. NOTE: Many more useful tools
are available at your local dealer or the Shop-Vac
5. Plug the cord into the wall outlet. Your cleaner is ready for use.
I = ON, O = OFF
ACCESSORIES, HOSES AND WANDS
All Shop-Vac
vacuums covered in this manual come with accessories to cover wet and dry cleanup jobs.
®
Not all vacs include all accessories shown.
Nozzles and Accessories
Lock
Lock
Carpet
Tool
Insert
Double
Blade
Squeegee
Insert
Floor
Brush
Insert
14" (35.56cm) ABS Plastic
Master Nozzle
Inserts lock into place by
sliding red buttons. Elbow swivels.
Carpet
Tool
Insert
Squeegee
Insert
Deluxe 12" (30.48cm) Nozzle
Inserts snap-in and out.
Elbow swivels.
FILTER INSTALLATION AND MAINTENANCE
FILTRATION SYSTEM
There are a variety of filters available for your vacuum. There are cage filters that install onto the underside
of the tank cover and tank filters that install into the tank. The filters are grouped into three filtration
categories. General filtration is used for large debris; such as, wood chips, nails and gravel. Medium
filtration is used for medium debris; such as, dirt, sand and sawdust. Fine filtration is used for fine debris;
such as drywall dust, cold ash and cement dust. It is important to have the correct filters installed for your
cleaning operation to protect your vacuum motor. tHe moSt eFFICIeNt FIltratIoN For your vaCuum IS a
FINe FIltratIoN CaGe FIlter wItH a FINe FIltratIoN taNk FIlter.
NOTE: When using the vacuum to pick up very fine dust. It will be necessary to empty the tank and clean
the cage filter at more frequent intervals to maintain maximum pick up power or add a disposable filter bag.
DRY PICK UP OPERATION
NOTE: Never use the vacuum for dry pick up without a dry use filter installed. Using the vacuum without a
filter will cause dust to discharge from the blower port and cause damage to the motor.
WARNING
BEFORE REMOVING THE TANK COVER.
Follow the instructions for the filter that came with your vacuum. Some filters mentioned do not come
standard with all vacuums. Additional filters are available at your local dealer or the Shop-Vac
PAGE 8
(1.25" (3.18cm)
utility nozzle
shown)
All Friction Fit
Accessories
Insert wand end or hose
into accessory and twist to
form a tight fit.
Brush Insert Shown
14" (35.56cm) Metal
Master Nozzle
Inserts lock into place by
sliding insert onto nozzle.
Dual Surface Selector Nozzle
Levers control brush position for
various types of cleaning.
–
ALWAYS DISCONNECT THE PLUG FROM THE WALL OUTLET
website.
®
Hoses
All Friction Fit Hoses
Insert machine hose end into
tank and twist to form a
tight fit.
Posi-Lock Hoses
Insert hose collar onto
threaded tank inlet and
tighten. Do not over-tighten.
Wands
All Friction Fit Wands
Insert wand ends together
and twist to form a tight fit.
Positive Locking Wands
Insert wand ends together
until metal push button locks.
Locking Nut Wand End
Insert wand end over nozzle
and tighten nut.
website.
®
Publicité
