Operation
Storing food
To get the best results from your appliance, follow these instructions:
Only store foodstuffs in the appliance when it has reached the correct operating temperature.
Ensure GN container bays are full at all times, even if the GN containers are unused or empty.
Empty bays will greatly reduce efficiency of the appliance.
Always close the door lid or drawer when not in use.
Do not place uncovered hot food or liquid inside the appliance.
Wrap or cover food where possible.
Do not obstruct the fans inside the appliance.
Avoid opening the doors/drawers for prolonged periods of time.
The maximum load for a shelf/drawer is 30 kg.
The food must be put into container before placed into cabinet or on the shelf. Food must not
be placed into food cabinet directly.
When wet food/vegetable is put in the Saladette, it's normal that ice (snow) appears on the
surface.
Turn on
Close the door/lid/drawer of the appliance.
Ensure the power switch is set to [ O ] and turn on at the socket.
Switch on the Power [ I ]. The current temperature within the appliance is displayed.
The
on the control panel will flash for 3-min to indicate a delay between the motor
compressor being stopped and then restarted.
Temperature setting and control(DIXELL)
The front panel of the thermostat
1. Defrosting light
2. Compressor operation light
3. Digital thermostat
4. Programming key (Service agent only)
5. Temperature modification keys
6. Manual defrost
How to see the set point
Push and immediately release the SET key, the set point will be showed;
Push and immediately release the SET key again or wait about 5s to return to • normal
visualisation.
How to change the set point
Push the SET key for more than 2 seconds to change the set point value;
The value of the set point will be displayed and the " °C " starts blinking;
To change the set value push the „
To memorise the new set point value push the SET key again or wait 10s.
P2M031STD - Ver.1.0
" (up) or „
" (down) arrows within 10s.
9
GB