Publicité
Les langues disponibles
Les langues disponibles
Assembly & Set-Up
Contents of Carton
•
One Hauler Assembly
•
One Hardware Pack
NOTE: All references to LEFT, RIGHT, FRONT, and
REAR indicate the hauler position when seated in
the tractor's operator seat and facing forward.
Hardware Pack
1
3
2
4
Figure 3-1
The contents of the hardware pack are listed below
and referenced in Figure 3-1.
1.
Two (2) Flat Washers, .760 x 1.490 x .060
(736-0351)
2.
Two (2) Flange Washers, .781 x 1.590 (736-
04228A)
3.
Two (2) Clevis Pins, .50 x 3.25 (711-06472)
4.
Four (4) Cotter Pins (714-3020)
Hauler Preparation
1.
Carefully unpack the contents of the carton
and unwrap and cut any cable ties securing
the contents in the carton.
2.
Carefully stand the hauler up as shown in
Figure 3-2.
Figure 3-2
•
One Tongue Assembly
•
One Operator's Manual
3.
Before installing the wheels, the axles and
the inside of the rims should be greased.
Apply some grease (not supplied) to the
exposed portion of the axle and coat the
axle completely. Apply a small amount of
grease (not supplied) into the rim hub.
4.
Slide the inner flat washer from the
hardware pack, the tire and outer flanged
washer from the hardware pack onto the
axle as shown in Figure 3-3. Make sure the
valve stem on the tire rim is facing outward.
Figure 3-3
5.
Install the cotter Pins from the hardware
pack through the holes in the axles to
secure the tires in place. See Figure 3-4.
Figure 3-4
6.
Carefully set the hauler down onto its
wheels.
7.
Locate the panel latch on the front of the
hauler. Push the panel latch inward and raise
the sides of the hauler bed. See Figure 3-5.
•
Two Wheel Assemblies
1
8.
Repeat Step 7 on the other side of the bed.
9.
With both sides now raised, lift the front
panel up and insert the front panel into the
side panels pull outward on the tabs until
they click into place. See Figure 3-6.
1
1
10.
Lift the tailgate latches and then lift the
tailgate into place. See Figure 3-7.
3
2
Figure 3-5
2
1
Figure 3-6
1
1
2
Figure 3-7
5
Publicité
