afx light CLUB-710-IP Manuel D'utilisation page 4

2. Connection of Signal Cable
You can use the 3-pin XLR cable to connect the output socket of the master and the input socket of
the slave light. Connect the DIGITAL OUT socket of the master and the IN socket of the slave light,
then, connect the OUT socket to the IN socket of the next light.
The connection between the output of master and input of product, it's available to use the 3 pins
XLR cable which provided by the manufacturer. Signal cable from the DMX output of the controller
to the input of the first master light, and connect to the DMX input of second slave light from the
DMX output of the first master light, analogously, till connected all the slave lights, and insert the
last connector to the output of the final light. (Notice: the diameter of core of every cable should
be 0.5mm at least, double core shelter cable should be used).The signal connecting must use the
attached 3 pins XLR cable. Notice, all the internal lead wire of the 3 pins XLR cable should not touch
to each other or connect to the connector.
A DMX signal terminator is recommended on the last unit of the chain. DMX terminator is a XLR
connector with a 120Ω resistor between the pin 2 and pin 3 of the XLR connector
CONTROL PANEL
Use Menu button to choose a function among MODE, SET, DMX, REST,
TEST and TEMP. Press Enter button to enter in the menu of the selected
function
Use Up and Down button to select the parameters then press Enter button
to set the selected parameter
Check the following function table :
MENU
ADDR
MODE AUTO
SOUN
MIC
LOAD
SET VER
CALI
MOD1
DMX
MOD2
REST ON/OFF
rXXX
gXXX
MANU
bXXX
UXXX
TEMP TXXX
DMX channel chart: please refer to LAST page
EN 4
VALU A001~A XXX (AXXX)
SLAV
ALON /(AU-A)
IP1-8
MAST /AU-M)
IP1-7
M-XX
ON/OFF
V-x.x
Code (password: 088)
CH03-CH06
C000-255
C000-255
C000-255
C000-255
SP_1~SP_5 (Speed)
ALON (SO-A)
MAST/(SO-M)
8.8.8.8.
MENU UP DOWN
DESCRIPTION
DMX address setting
Stand-alone mode (Slave mode)
Internal programme (alone)
with speed control
Auto-run (Master) with speed
control
Sound control (alone)
Sound control (Master)
Mic sensitivity setting
Reload data
Software version
Input password
Calibration
10CH
8CH
Reset to factory default
Manual control red LED
Manual control green LED
Manual control blue LED
Manual control white LED
Current temperature
© Copyright LOTRONIC 2023
ENTER