Skil CR541801 Guide D'utilisation page 23

TROUBLE SHOOTING
Problem
Tool does not start.
Blade does not come up to
speed.
Excessive vibration.
The blade does not follow
a straight line.
Cut binds, burns, stalls
motor when ripping.
Blade slipping.
Cause
1. Battery pack is depleted.
2. Battery pack is not
installed properly.
3. Burned out switch.
1. Low battery.
1. Blade out of balance.
2. Workpiece not clamped
or supported properly.
1. Blade teeth are dull.
2. Foot is out of line or bent.
3. Blade is bent.
1. Dull blade with improper
tooth set.
2. Blade binds.
3. Improper workpiece
support.
1. Tool does not cut
workpiece.
Remedy
1. Charge the battery.
2. Confirm battery is properly
secured to the tool.
3. Have the switch replaced by
an Authorized SKIL Service
Center or Service Station.
1. Recharge the battery pack or
use a fully charged pack.
1. Discard blade and use a
different blade.
2. Clamp or support workpiece
properly according to this
manual.
1. Change to a new blade.
2. Have the tool repaired by
an Authorized SKIL Service
Center or Service Station.
3. Change to a new blade.
1. Discard blade and use a
different blade.
2. Reassemble the blade
and tighten the washers
according to this manual.
3. Clamp or support workpiece
properly according to this
manual.
1. Reassemble the blade
and tighten the washers
according to this manual.
23