Skil CR541801 Guide D'utilisation page 15

Lock-Off Button (Fig.4)
Your tool is equipped with a lock-off button,
located on the handle above the trigger switch.
It reduces the possibility of accidental starting
for personal safety protection.
The lock-off button must be pushed in before
pulling the trigger switch.
Depth-of-Cut Adjustment (Fig.5)
Your tool is equipped with a depth-of-cut adjustment lever, located beside the depth-of-cut
gauge.
a. Detach the battery pack from the tool.
b. Loosen the depth-of-cut adjustment lever.
c. Hold the foot of the saw flat against the edge of the workpiece and then raise or lower the
saw until the indicator mark on the depth-of-cut gauge aligns with the desired depth-of-cut
mark.
d. Securely tighten the depth-of-cut adjustment lever at the desired depth of cut.
NOTICE: Check the depth-of-cut setting. Not more than one tooth length of the blade should
extend below the material to be cut.
Fig. 5
Indicator Mark
Depth-of-cut Ad-
justment Lever
Fig. 4
ONE TOOTH LENGTH SHOULD
PENETRATE WOOD FOR MINI-
MUM SPLINTERING
Lock-Off Button
Trigger Switch
15