Installation; Before Using This Appliance; Installing Your Appliance - Summit RFBW61G Mode D'emploi

Before Using This Appliance

CAUTION: After unpacking you MUST allow this appliance to stand upright
for at least 2 hours to allow the lubricant and refrigerant to drain back into
the compressor and stabilize. Failure to do so may adversely affect
performance and the lifetime of this unit.
•
Remove all exterior and interior packing.
•
Check to be sure shelves are installed and that the strips of tape
holding them in place have been removed.
•
Level the appliance with the adjustable legs provided.
•
All controls should be in the OFF position.
•
Clean the interior surfaces with lukewarm water using a soft cloth. Any
plastic odor that you notice when you first open the doors will dissipate
once the appliance is operating.

Installing Your Appliance

•
This appliance is designed to be free-standing only, and should not be
recessed or built-in.
•
Install the anti-tip bracket included with the unit by following the
enclosed instructions.
•
Place your appliance on a floor that is strong enough to support it when
it is fully loaded. Be sure the appliance is level. (Level the unit cabinet
by adjusting the legs at the front.)
•
For proper air circulation, leave at least 2 inches of space between the
back of the unit and the wall behind, and 4 inches at the sides and top.
•
Plug the unit into a 120V AC 60Hz electrical source. The fuse or circuit
breaker should be rated for 15 amperes.
•
The unit is designed to be used in a stable environment where the ideal
ambient temperature is 72°F or less. Extremely warm or cold ambient
temperatures may cause the appliance to perform improperly.
•
Avoid locating the unit in moist areas.

INSTALLATION

4