Installation; Cabinet Location Guidelines; Electrical Connection - Summit SCRR231 Mode D'emploi

IMPORTANT!

If the unit has recently been transported, let it stand upright for a minimum of
24 hours before plugging it in.

Be sure there is proper ventilation around the unit in the area where it will
operate. Leave at least 8" at the back.

Make sure all accessories are installed (i.e. shelves, shelf clips, casters)
before plugging the unit in.

Be sure the unit has dropped down to desired temperature before loading it
with product.

Please read through the manual in its entirety.

Cabinet Location Guidelines:


Install the unit on a strong and level surface.
–
Unit may make unpleasant noises if surface is uneven.
–
Unit may malfunction if surface is uneven.

Install the unit in a well-ventilated indoor area.
–
Unit performs more efficiently in a well-ventilated area.
–
For best performance, maintain a clearance of 8" at the back of the unit.
–
Outdoor use may cause decreased efficiency and damage to the unit.

Avoid installation in a high humidity and/or dusty area.
–
Humidity could cause unit to rust and experience decreased efficiency.
–
Dust collected on the condenser coil will cause the unit to malfunction.
Clean the condenser at least once a month with a brush or clean cloth.

Select a location away from heat and moisture-generating equipment.
–
High ambient temperatures will cause the compressor to overwork, leading
to higher energy bills and gradual breakdown of the unit.

Electrical Connection:


Be sure the required compressor voltage is being supplied at all times. Low or
high voltage can detrimentally affect the refrigeration unit.

All units should be plugged into a grounded and properly-sized electrical outlet
with appropriate overcurrent protection. Refer to the electrical requirements on
the nameplate.

Be sure the unit has its own dedicated outlet.

Do not use an extension cord.

INSTALLATION

PLEASE READ BEFORE INSTALLATION
7