Location Of Parts; Installation Instructions; Before Using Your Appliance; Installation Of Your Appliance - Summit SPR7OSST Série Manuel D'utilisation

Masquer les pouces

Table des Matières

Les langues disponibles

Lock (not shown)

at top of door

Glass shelves (3)

Evaporator

(behind rear wall)

Bottom grille

Adjustable feet (4)

BEFORE USING YOUR APPLIANCE

• Remove the exterior and interior packing.

•

CAUTION:

After unpacking you MUST allow this appliance to stand upright for at least 2 hours to

allow the lubricant and refrigerant to drain back into the compressor and stabilize. Failure to do so

may adversely affect performance and the lifetime of this unit.

• Clean the interior surface with lukewarm water using a soft cloth.

INSTALLATION OF YOUR APPLIANCE

• The appliance is designed for built-in or recessed or free standing installation for indoor or outdoor

use.

•

CAUTION:

This appliance is not designed for the storage of medicine or other medical products.

• Place your appliance on a floor that is strong enough to support it when it is fully loaded. To level the

unit, adjust the front leveling legs.

• For free standing installation, 5 inches (127mm) of space between the back and sides of the unit and

4" at the top are suggested, which allows the proper air circulation to cool the compressor and

condenser. Even for built-in installation, it is a must to keep ¼" (6.35mm) space on each side and at