Publicité
Les langues disponibles
Les langues disponibles
Turning power off
Turning power off with monitor buttons
1. Touch the POWER button.
The recognition screen appears.
2. Touch [OK].
The power is turned off. (Standby mode)
TIPS
• If about 15 seconds elapses while the recognition screen
appears, the power will automatically turn off.
Mounting Precautions (For SHARP dealers and service engineers)
• When installing, removing or moving the monitor, ensure that this is carried out by at least 4 people.
• Be sure to use a wall-mount bracket designed or designated for mounting the monitor.
• This monitor is designed to be installed on a concrete wall or pillar. Reinforced work might be necessary for some materials
such as plaster / thin plastic board / wood before starting installation.
This monitor and bracket must be installed on a wall which can endure at least 4 times or more the weight of the monitor.
Install by the most suitable method for the material and the structure.
• To attach a VESA-compliant mounting bracket, use M6 screws that are 5/16 inch (8 mm) to 3/8 inch (10 mm) longer than the
thickness of the mounting bracket.
• Do not use an impact driver.
• After mounting, please carefully ensure the monitor is secure, and not able to come loose from the wall or mount.
• Do not use any screw holes other than VESA holes for installation.
• When moving this monitor, be sure to hold it with the handles, the unit sides, the unit bottom or the unit top. Do not grasp the
screen, unit corner, tray, speaker, or speaker cover. This may cause product damage, failure, or injury.
• If you need to temporarily place the monitor on a table or other surface during installation, spread a thick soft cloth on the
table to prevent damage to the screen and table.
• Prior to repacking or removal, remove the tray and speaker covers.
• When using the monitor laying flat on a surface (when the monitor is tilted more than 20 degrees upward from the
perpendicular in relation to a level surface), consult an authorized SHARP dealer because there are some specific mounting
conditions.
nAttaching the Tray
Tray mount fitting
Caution
• When attaching the tray, do not pinch the USB cable on the back
of the tray.
Turning power off with remote control unit
1. Press the POWER button or MONITOR OFF button.
The power is turned off. (Standby mode)
5/16 - 3/8 inch (8-10 mm)
Screws (M6)
Mounting bracket
Monitor mounting
Push until the tabs lock
into place (4 places)
Tabs (4 places)
9
E
Publicité
