Maintenance; Cleaning Pad; Cupule, Sensors, Squeegee, Corners - ECOVACS ROBOTICS Winbot 9 Mode D'emploi

Before performing cleaning and maintenance on WINBOT 9, move the Bottom Power Switch
O
to the " " position and unplug it from the receptacle.

4.1 Cleaning Pad

Turn the robot over and remove the Cleaning
Pad. Rinse the Cleaning Pad and allow it to dry
completely before re-attaching it to the robot.
Do NOT use a wet Cleaning Pad
*
on WINBOT 9, or it may slip on the
window.

4.2 Cupule, Sensors, Squeegee, Corners

Cupule
Turn the robot over and wipe any debris from
the surface of the Cupule with the provided
Finishing Cloth to maintain suction.
Edge Detection Sensors
Turn the robot over and wipe the four Edge
Detection Sensors clean with the provided
Finishing Cloth to maintain their effectiveness.

4. Maintenance

Wheel Sensor
Turn the robot over and wipe the Wheel
Sensor with the provided Finishing Cloth
to maintain its effectiveness.
Squeegee
Turn the robot over and wipe the Squeegee
clean with the provided Finishing Cloth
to maintain its effectiveness.
13
EN EN