Publicité
Les langues disponibles
Les langues disponibles
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
the selected kind of machine and welding standard, then Display 2.
After one of the cables was connected to its appropriate connector at
the hydraulic and control unit, Display 3 shows the the data of the next
welding, including time of day, date, report number, and joint number,
along with, in the second-to-last line, the actual input voltage and — if
the cable of the heating element for butt welding is connected — the
actual and nominal heating element temperature before and after the
slash. The last line shows no report number, but "No contact" if the
welding cable to an electrofusion fitting is connected to the hydraulic
and control unit, but not to the fitting to be worked yet.
From Display 2 and Display 3, it is possible to access the Configuration
Menu in which the default behavior of the welding machine can be
configured. To access it, press the MENU key and then, on the follow-
ing enter-code screen, type the access code using the alphanumeric
keypad or hold the transponder card in front of the RFID reader. When
the menu is accessed from Display 2, all parameter settings can be
configured; when it is from Display 3, only those that make sense for
the currently started welding process are available.
The alphanumeric keypad is designed and works like the
keypad of a traditional mobile phone. If an input is numerical,
the keypress generates the number found on the respective
key. For an alphanumeric input, all characters found on a key
Info
can be generated by pressing that key repeatedly. As soon
as the desired character can be read on the screen, wait a
little longer until you press the next key to use the displayed
character.
Pressing the ñ and ò cursor keys in the menu that appears (Display 4),
you can select a menu option, then access the selected sub-menu by
pressing the MENU key again.
In the Machine Data sub-menu, the type of machine
(its designation and its cylinder section) to which
the hydraulic, control, and data logging/report
generation unit is connected, has to be defined
(see the arrow symbol in Display 5). This definition
is preset ex works and needs changing only when, exceptionally, the
control unit is connected to a different machine. To change it, select
the proper machine type by pressing the ñ or ò cursor keys and con-
firm by pressing the START/SET key.
If the wrong machine is selected in this menu, all pressure
computations that the machine makes when welding in the
WeldControl mode, will be wrong! Changing to another
Important
machine requires consultation with the manufacturer or an
authorized service shop, as a sensor calibration is then also
recommended. This step requires proper authorization
As an addition to the preinstalled machines, user-
defined machine types can be set as needed at the
unused menu entries (a designation for the machine
and its cylinder section have to be entered).
The Sensor Parameters sub-menu, used to calibrate
the pressure and the temperature sensors, should
be accessed by authorized staff only and is, there-
fore, protected by another access code disclosed
only to such personnel as is allowed to manage
these settings.
Version January 2018
HÜRNER WeldControl EF 160 User's Manual
Next welding
15:44:52
29.05.12
235V
135C/220C
Rep. No. 00072/00002
Display 3
CODE : 415311
Settings
-M-
>Reporting
-M-
Sensor Parameter-M-
Machine Data
-M-
Display 4
>HST 160
1.95
HST 200
3.16
HST 250
5.10
HST 315
5.89
Display 5
EN
13
Publicité
