Publicité
Les langues disponibles
Les langues disponibles
Advice on arranging your wine cabinet
Your EuroCave wine cabinet has been designed to store a maximum
number of bottles in total safety. We recommend that you abide by the
following few suggestions in order that the maximum storage capacity can
be obtained.
•
Make sure that you distribute your bottles as evenly as possible onto the
various shelves contained in your cabinet so as to spread the weight equally.
Also take care that your bottles do not touch the cabinet's back wall.
•
Make sure you distribute your bottles evenly throughout the height of
the wine cabinet (avoid loading all bottles at the top or all bottles at the
bottom).
•
Be sure to observe the storage recommendations in accordance with
the type of storage facility provided by your cabinet. Never stack more
than one layer of bottles on a sliding shelf.
Adding or changing the position of a sliding shelf (ACMSC)
If the sliding shelf is already in place in your cabinet:
•
Fully unload the sliding shelf.
•
Then lift out the sliding tray by sliding it forwards whilst at the same time lifting it from the front.
•
Find the runner guides on the left and right and remove.
•
Reinstall them in the new position (see diagram below).
a.
b.
d.
Slide the shelf along until the back fasteners of the shelf lock into
the slots provided in the runners.
f.
Note: In order to prevent the shelf from tipping, ensure that the studs on each side of the shelf are pushed all
14
GB
5/ LAYOUT – STORAGE
TAC !
2
1
the way into the holes before pushing the shelf back in.
•
If you have sliding shelves, for easy day to day access it is a good idea to
place them in the upper part of your wine cabinet.
•
For this reason, place one or two bottles of each of your
various wines on the sliding shelves and your reserve
stock on the storage shelves. Then all you have to do is
top them up as required.
•
When using your wine cabinet, never pull out more than
one sliding shelf at a time.
Warning: Never modify the position of your wine cabinet's
bracing bar, and never manoeuvre this part when the cabinet is
stocked (259).
1
c.
2
Place your shelf on the left and right runners and start by locking
the back section of the shelf.
e.
Then place the front studs of the shelf into the slots provided in the
front section of the runners. It is necessary to jiggle the shelf in order
to make the studs slot into the holes. Tip: Start by inserting the left
stud. The right stud will then easily slot into the oblong hole.
g.
2
2
1
1
Publicité
