Publicité
Les langues disponibles
Les langues disponibles
Precautions
•
Do not place your cabinet in an area likely to be flooded.
•
Do not position your cabinet near to a source of heat or expose it to
the effects of direct sunlight.
•
Prevent water from splashing on the entire rear section of the appliance.
•
Position your appliance so that there is a minimum space of 5 – 10 cm
between the wall and the rear wall of your cabinet.
•
If you are positioning your
cabinet under a work
surface, leave a minimum
space of 5 cm all around the
appliance including under
the work surface. Allow for
a ventilation grill on the
w o r k
s u r f a c e
(recommended).
•
Install the carbon filter,
which you will find inside
your cabinet's "accessories"
packet, by placing it in the
air circulation hole located inside the cabinet on the top left hand side
(see diagram below).
•
Arrange the power lead so that it is accessible and does not come into
contact with any component of the appliance.
•
Slightly tilt the cabinet backwards to adjust the front feet (adjusted by
screwing or unscrewing), so that you can level your cabinet (use of a
spirit level is recommended).
•
For single-temperature models only:
- If you notice low humidity levels (<50%) a few days after setting your
wine cabinet into operation, we recommend that you use the humidity
cartridge, supplied in a bag with the appliance. Place it at the bottom
of the cabinet, under the rack in the drip tray provided (see diagram
below).
- When using for the first time, completely immerse your cartridge in tap
water for a few minutes to saturate it then allow it to dry. Depending
on external conditions, it may be necessary to add a 10cl glass of water
after several months.
•
Never obstruct the front ventilation grid.
Beware: any changing of the control panel LED should only be
carried out by a qualified electrician.
8
GB
4/ INSTALLING YOUR WINE CABINET
Fitting the handle
(Full Glass door only on models S-059V3, V-059V3,
S-259V3, V-259V3)
•
Unscrew the three screws placed on the side of the door, using the Allen
wrench, which you will find in the handle's box.
•
Position the handle on the specially designed groove on the door frame
(figure 2).
•
Insert the handle all the way into the groove using a forward movement
Revissez les trois vis (figure 3).
•
Screw the three screws back on (figure 3).
Fig.1
•
Take care not to catch the seal when screwing.
Note: adjustment of the handle is possible thanks to the oblong holes.
View from above
Handle
Front
Figure 1
Fig.2
Figure 2
Note : Un Install the stop (which is located in the accessories bag) at the
Fig.3
back of the cabinet (on models S-259V3, V-259V3) / see diagram).
•
This allows a space of 7 cm to be maintained
between the wall and the rear of the cabinet.
This space allows your cabinet's power
consumption to be optimised.
•
Place the 2 caps in the 2 holes at the top of
the cabinet.
•
Do not push the caps all the way in, in order
to allow the rear stop to be installed.
•
Slide the rear stop between the caps and the
wall of the cabinet, then push the 2 caps all
the way in.
Installation of two cabinets side by side
Caution: In the case of two side by side cabinets installed in extreme
conditions (Temperature >30°C - Relative Humidity > 70%), in order to
prevent condensation of stagnant air between the walls, please leave either
a minimum space of 5 cm between the two cabinets, or fill the space with
a foam sheet to remove the void.
Fig.1
Fig.2
Seal
Door frame
Fig.3
Figure 3
Publicité
