Chauvin Arnoux DigiFlex MA400D Notice De Fonctionnement page 16

Thank you for purchasing a DigiFLEX MA400D current
meter with flexible sensor. For best results from your
instrument:
„ read this user's manual carefully,
„ comply with the precautions for use.
WARNING, risk of DANGER! The operator must
refer to these instructions whenever this danger
symbol appears.
Equipment protected by double insulation.
Must not be applied to or removed from bare
conductors at dangerous voltages. Type B cur‑
rent sensor as per IEC 61010‑2‑032.
Battery.
The CE marking indicates conformity with
European directives, in particular LVD and EMC.
The rubbish bin with a line through it indicates
that, in the European Union, the product must
undergo selective disposal in compliance with
Directive WEEE 2002/96/EC. This equipment
must not be treated as household waste.
Definition of measurement categories:
„ Measurement category IV corresponds to measurements
taken at the source of low‑voltage installations.
„ Measurement category III corresponds to measurements
on building installations.
„ Measurement category II corresponds to measurements
taken on circuits directly connected to low‑voltage
installations.
PRECAUTIONS FOR USE
This instrument is protected against voltages of not more than
1000V with respect to ground in measurement category III
or 600V in CAT IV between the sensor and the conductor of
which it measures the current.
The protection provided by the instrument may be impaired
if the instrument is used other than as specified by the
manufacturer.
„ Do not exceed the rated maximum voltage and current or
the measurement category.
ENGLISH
16