Smartwares RM218 Mode D'emploi page 8

Do not install the alarm in a place with difficult access, which could
make it difficult to operate the test button and maintenance. The
alarm can be installed quickly and easily. Install the base plate on the
selected location using the provided screws.
3. Mounting
* Take the fixation pin out of the ground plate
* Screw the mounting plate with 2 screws on the celling
* Activate the smoke alarm device before mounting
* Fix the smoke alarm device on the mounting plate by turning,
till you hear a "click"
* Put the fixation pin in the hole
* Test the smoke alarm device by pushing the test button
4. Caution
* Do not cover the smoke alarm device with tape! When SMOKE
is detected, you will hear a loud intermittent sound (85dB).
5. Recommendation
* Increase the detection area by installing several smoke alarm
devices
During the smoke alarm is alarming, you push the test button, it will
be paused the smoke alarm alarming for approx. 10 minutes. The
red LED will flash every 8 seconds, it indicates the smoke alarm
device is running into the hush mode.
ALARM SILENCE (hush mode)
-7-
>>>