Remote Control; Replacing The Battery; Thermostat - External Chronothermostat - Ferroli ATLAS Manuel D'installation, D'utilisation Et D'entretien

4.6.10 Menu 10 – settings by technician
This selection is reserved exclusively for the authorised COLA service centre technician.
4.6.11 Menu 11 – ECO mode
The selection ON in the ECO mode limits the stove to operate in modulation, i.e. at minimum power and minimum
ventilation. The display shows NIGHT ECO and the corresponding symbol lights up.

4.7 Remote control

The remote control is a device that transmits through an infrared diode. Therefore it must be pointed towards the
receiver unit fitted in the control panel.
The remote control allows the following operations:
P1 and P3: Buttons to set the power
level
P5: Button for accessing the MENU
P7: Button to activate/deactivate
ECO mode (activate
power)
P9: On/Off button and for exiting the
MENU

4.7.1 Replacing the battery

The remote control is powered by a 3-volt CR2025 type battery located in the bottom of the device. For its insertion
and possible replacement, proceed as follows:
- Operate the lever indicated;
- Pull out the battery tray and replace the battery (3-volt CR2025 model) respecting the polarity;
- Insert the tray;
- Check proper functioning.
- Keep the remote control away from direct heat sources and water.
- The remote control battery must be replaced and disposed of safely in compliance with
local regulations;

4.8 Thermostat - external chronothermostat

The standard unit controls the room temperature by means of a digital probe that adjusts the power according to the
set temperature.
minimun
P2 and P4: Buttons to set the room
temperature
P6: Button to exit the MENU
P8: Button to activate/deactivate
STANDBY mode
P10: Button to activate/deactivate
the CHRONO function
battery tray
lever
44 ATLAS