Transport And Installation; Place Of Installation, Positioning And Fire-Prevention Safety - Ferroli ATLAS Manuel D'installation, D'utilisation Et D'entretien

2

TRANSPORT AND INSTALLATION

2.1 Packing, handling, shipment and transport
The stove complete with packing can be lifted using a lift truck, inserting the forks (of suitable length) in the special
spaces in the wooden pallet. Make sure the equipment used for lifting and transport can take the weight of the
stove, specified on the dataplate and in this manual.
Avoid taking the load in areas where it could be a danger if dropped.
Open the packing, remove the stove from the pallet and position it in the required place, making sure it complies
with that provided for. Set the stove down on the floor carefully without bumping and position it in the required place.
Make sure the floor can take the weight of the stove, otherwise consult a specialised technician.
Disposal or recycling of the packing must be carried out by the end-user in compliance with the current local
regulations.

2.2 Place of installation, positioning and fire-prevention safety

The place of installation must be sufficiently ventilated to allow the removal of any combustion smoke leaks.
The unit is suitable for operation in domestic environments with min. temperature not below 0°C.
To prevent the risk of fire, the structures surrounding the stove must be protected from the heat.
Floors in wood or in any flammable material must be suitably protected at the base with steel or toughened glass
panels; the protection must cover the base and also a certain area in front of the stove.
Any wooden boards or beams above or crossed by the flue must be suitably protected in conformity with the
requirements of the specific current installation standards.
The minimum front distance for the protection of flammable objects is 1.5 m. The minimum safety distances from
flammable materials must comply with the following table:
Every installation must provide for an easily accessible technical space for periodical maintenance.
The stove is provided with 6 adjustable feet to facilitate positioning on not perfectly flat floors. To adjust the height,
tilt the stove slightly and turn the feet as required. The stove is supplied with the ambient sensor fixed through a
wrapper on the back of the stove; we recommend to remove the wrapper and to locate the sensor in the best
position possible as to improve the temperature registration in accordance with the ambient context and the length
of the cable. As for temperature registration done at a certain distance we reccomend to install the ambient
thermostat/ambient programming clock-thermostat – see. par.4.8.
Antiwind
grille
Flue
Flue connection
Air inlet
min. 100 cm²
Floor protection base
36
A = 300
mm
B = 200
mm
C = 1500
mm
D = 200
mm
ATLAS