Axis D2110-VE Manuel D'installation page 23

Connectors
Network connector
RJ45 Ethernet connector with Power over Ethernet Plus (PoE+).
CAUTION
Risk of damage to the device. Do not power the device with both PoE and DC.
Network connector (PoE out)
Power over Ethernet IEEE 802.3at type 2, max 30W
Use this connector to supply power to another PoE device, for example a camera, a horn speaker,
or a second security radar.
Note
The PoE output is enabled when the radar is powered by a 60 W midspan (Power over
Ethernet IEEE 802.3bt, type 3).
Note
If the radar is powered by a 30 W midspan or DC power, the PoE out is disabled.
Note
Maximum Ethernet cable length is 100 m in total for PoE out and PoE in combined. You can
increase it with a PoE extender.
Note
If the connected PoE device requires more than 30 W, you can add a 60 W midspan
between the PoE out port on the radar and the device. The midspan will power the device
while the security radar will provide the Ethernet connection.
I/O connector
Use the I/O connector with external devices in combination with, for example, event triggering
and alarm notifications. In addition to the 0 V DC reference point and power (DC output), the I/O
connector provides the interface to:
Digital input - For connecting devices that can toggle between an open and closed circuit, for
example PIR sensors, door/window contacts, and glass break detectors.
Digital output - For connecting external devices such as relays and LEDs. Connected devices
can be activated by the VAPIX® Application Programming Interface, through an event or from
the product's webpage.
6-pin terminal block
AXIS D2110-VE Security Radar
23
EN