Eurocave CL-C Guide D'utilisation page 13

Important
The apparatus must be disconnected from the electrical power source
during this operation.
• Original location of the drain hole
Your cellar conditioner has been designed to enable the evacuation of
condensation, either within the cellar, if there is inadequate hygrometry, or
outside the cellar.
Ex-works, the unit is set for evacuation outside the cellar.
Fo l l ow these steps to connect the evacuation pipe:
• Remove the front cover by undoing the 4screws.
• Place the pipe in the base plate. (see drawings).
• Connect the elbow joint, located at the other end of the pipe, onto the tube.
protrudes from the vertical wall.
• Screw the lid back on.
• Have your appliance reconnected by a qualified electrician, complying with
the recommendations in section 6 (safety recommendations)
TIP: depending on the installation, you might
need to extend the evacuation pipe. To do this,
we advise you to use a flexible hose (not
supplied) which you can connect to the
existing pipe.
10
• Modifying the condensation evacuation
The apparatus must be disconnected from the electrical power source during
this operation.
a) Have your cellar conditioner disconnected by a qualified electrician.
b) Remove the cover from the apparatus by unscrewing the 4 screws.
c) Remove the plastic drain hose and its elbow joint.
d) Remove the back plate (1) by unscrewing the 2 screws (2) and sliding the
plate backwards.
e) Selection of your pipe output direction (left or right of the unit).
f) Remove the side grommet ((3) or (3') on the selected side) using a
screwdriver and pliers.
WARNING: when carrying out this operation, take care not to injure yourself
with the metal sheet or damage the conditioner sump.
g) Remove the pipe (5) as well as the rubber part located on the side wall and
turn the drain plug (4) to the selected side.
h) Place the grommet (black rubber component found in the screws bag) in the
hole of the lateral sump.
i) Slide the drain hose with its elbow joint into the previously made side sump
opening. Connect it to the drain outlet.
NOTE: depending on the selected evacuation side, you may need to shorten the tube.
j) Connect the hose (5) onto the elbow joint.
k) Retighten the back plate (1).
l) Screw on the front of the cellar conditioner.
m) Have your appliance reconnected, by a qualified electrician, complying with
the recommendations in section 6 (safety recommendations)
T I P : depending on the installation, you might need to extend the evacuation
pipe. To do this, we advise you to use a flexible hose (not supplied) which you
can connect to the existing pipe (5).
1 1