Publicité
Les langues disponibles
Les langues disponibles
INSTRUCTION FOR USE
Attention!
Before the fi rst use of the appliance you must remove protection foil, wash the device and bath with
water containing washing liquid and then dry with the cleaning cloth. Into the bottom of the bath
spread a vegetable oil and begin burning procedure by 230°of Celsius. Before you start cooking, it
is necessary make this burning procedure. The optimum is about 3–5 days use appliance as frying
pan, and then for cooking. If pans washing was done by chemical substances, we recommend to
use about 4-6 cycles as frying pan before you start cooking in it again. The device cannot be used
under any circumstances as a fryer or its substitute
Ignition the main burner:
With lighter:
Slide the door on the left front panel and turn gas valve control knob to the ignition position (Fig.2,
note 3 and Fig.6) and keep it pressed. Press the piezo lighter button couple of times. After burner
ignition, keep this button pressed for few second (about 10-20 sec.) until is the thermo fuse warmed
up, then release button. If the fl ame goes out, repeat the whole procedure again.
With electric burning:
Slide the door on the left front panel and turn gas valve control knob to the ignition position (Fig.2,
note 3 and Fig.6) and keep it pressed. Flame will ignite automatically. After burner ignition, keep this
button pressed for few second (about 10-20 sec.) until is the thermo fuse warmed up, then release
button. If the fl ame goes out, repeat the whole procedure again.
Ignition of the main burner and thermo regulation
Turn gas valve control knob to the ignition position (Fig.6) and set button of thermostat to required
temperature. Main burner will ignite.
Switching off of the main burner
The main burner is possible switch off with turning thermostat button to "0"position, or turning the
gas valve control knob to ignition position. Main burner will go out, but pilot burner keeps working.
Switching off the whole device
Set the gas valve control knob to position off. At this moment all burners goes out.
Filling water to the bath
Open valve for water fi lling and when achieve required volume of the water, simply close it. Water
fi lls up only when the lid of the bath is open.
Draining of the bath
Tilt the bath to required position for her drain with help of the manipulation handle. Attention! Before
you start draining of the bath, attach under overfl ow suitable container. Keep maximum attention if
you will be manipulating with boiling content. After successful bath draining, return it back to opera-
tion position.
ATTENTION!
When tilting the bath, main burner goes out, but automatically starting when returning bath into ope-
ration position. Because of this, make sure before you start draining of the bath, that main burner is
switched off.
9
Publicité
