Publicité
Les langues disponibles
Les langues disponibles
OPERATION
PARALLEL OPERATION
See Figure 14.
Parallel operation gives you the ability to link another
compatible Westinghouse inverter generator for combined
running and peak power output.
DANGER
Never connect or disconnect the parallel cable leads
when a generator is running. Failure to follow this rule
may lead to serious personal injury or death.
WARNING
is very important when the generators are used with
a transfer switch to supply power to a building. To
avoid serious personal injury or damage to electrical
devices, including the generators, do not try to power
an electrical system in a building without using an ap-
proved transfer switch.
NOTICE
Connecting to a generator that is
not compatible can cause a low voltage output that
may damage tools and appliances powered by the
generator.
Use only the Westinghouse 120V parallel cable kit that
came with your generator. Third party cables may not have
the ability to carry the increased voltage. If damage or loss
occurs to your cables, call Westinghouse customer service
for a replacement.
NOTE: Make sure both units have been shut down and
there are no devices connected to the outlet receptacles.
NOTICE
Arrange the generators in a "V" shape
to allow the heat from the exhaust to safely escape.
The exhaust heat from one unit may discolor or melt
the plastic case of the other unit if positioned too close-
ly together.
MAINTENANCE
WARNING
the spark plug boot (see figure 18) from the spark
plug when performing maintenance on the generator.
WARNING
with recommended or equivalent replacement parts.
Using an incorrect or incompatible part might create a
hazard that could result in serious personal injury.
WARNING
30 minutes before performing any maintenance pro-
cedure.
20 | English
Fire and electrocution hazard.
Correct connection of the cables
Accidental start-up. Disconnect
Replace damaged or worn items
Allow hot components to cool for
To install the parallel cable:
l Insert the cable end into one of the parallel ports on the
first unit. Insert the other end of the same cable into the
corresponding port on the second unit.
l Repeat steps with the other cable.
NOTE: It is important to connect both ends of the cable to
the same ports on both generators. Make sure the same
cable ends are connected to the same port on each gener-
ator before starting the generators.
Start one generator at a time. Wait for the first unit to run
at a stable idle before starting the second unit. Connect
one device at a time and allow the unit to stabilize before
connecting the next device.
To remove the parallel cable:
l Remove all devices from the generator's receptacles.
l Shut down both of the connected generators.
l Remove the parallel cable ends from the generator ports.
TRANSPORTING
l Turn off the generator.
l Allow the generator to cool a minimum of 30 minutes
before transporting.
l Replace all protective covers on the generator control
panel.
l Only use the generator's fixed handle to lift the unit or
attach any load restraints such as ropes or tie-down straps.
DO NOT attempt to lift or secure the generator by holding
onto any of its other components.
l Keep the unit level during transport to minimize the pos-
sibility of fuel leakage or, if possible, drain the fuel or run
the engine until the fuel tank is empty before transport.
CAUTION
generator or place it on its side. Fuel or oil can leak
and damage to the generator may occur.
WARNING
or gasoline. Wear protective clothing and equipment.
Wash all exposed skin with soap and water. Prolonged
skin contact with gasoline or engine oil may cause se-
vere skin irritation and other adverse reactions.
NOTICE
Check the physical condition of the
product prior to each use. Look for loose bolts, fluid
leaks, and other signs of wear. Replace all damaged
items. For replacement parts or assistance, contact
our customer service team.
To prolong the life of this product, follow the maintenance
instructions in this section. Contact customer service before
servicing any recall or warranty parts.
Fire hazard. DO NOT up-end the
Avoid skin contact with engine oil
Publicité
