Publicité
Les langues disponibles
Les langues disponibles
Program the function of the accessory module, and finally train the
detectors to the module (or to the wireless alarm system). For
some functions, it is also necessary to make individual settings
over the programming mode on the wireless alarm system.
6.1
Starting programming
To start programming, proceed as follows:
1. Make sure that the cover contact is open.
The green LED for power supply flashes (battery
operation) or lights constantly (PSU). The red fault LED
lights up.
2. Press SELECT.
LED number 1 also lights up blue.
3. You are now in programming mode.
6.2
Menu items in the main menu
The main menu contains the following menu items:
1. Train detector
2. Delete detector
3. Select channel
4. Test signal strength
5. Set outputs
6. Not used
7. Select function
8. Reset
Press SELECT to change between menu items in programming
mode. The display moves one menu item further with each key
press and returns to the top after reaching the last item. The
display of LED 6 is skipped here.
6.3
Selecting the functions on the WAM
The accessory module combines seven different functions, of
which one must be allocated. To select a function, proceed as
follows:
1. From the main menu, press SELECT repeatedly until LED
7 lights up (select function).
2. When LED 7 lights up, press SET once. You are now in
the submenu of the menu item 7 (select function). LED 1
lights up.
3. Press SELECT repeatedly until the LED of the desired
function lights up.
Note: If you wish to allocate a new function to a programmed
WAM, then all previously trained detectors are deleted.
->
LED 1 lights up.
->
LED 2 lights up.
->
LED 3 lights up.
->
LED 4 lights up.
->
LED 5 lights up.
->
LED 7 lights up.
->
LED 8 lights up.
39
Publicité
